This article contains BL610 Series Ninja® Professional Blender FAQs. These support the following product SKUs BL610, BL610CR, BL610A, BL610C, BL610A, BL611C, BL710WM, BL710WMC, BL710WMBF and CO610B.
1000-Watt Motor Base b. 72 oz.
Pitcher with Stacked Blade Assembly
Pitcher Lid with Pour Spout
All containers are made of BPA-free plastic.
The 72 oz. Pitcher and Lid are the only attachments that are compatible with the Ninja Professional Blender.
Hand-Washing: Wash the pitcher, lid, and blade assembly in warm, soapy water. When washing the blade assembly, use a dishwashing utensil with a handle to avoid direct hand contact with blades. Handle blade assembly with care to avoid contact with sharp edges. Rinse and air-dry thoroughly. b. Dishwasher: The pitcher, lid, and blade assembly are all dishwasher safe.
To clean the motor base, use a damp cloth to wipe clean.
Place the lid on the pitcher by aligning the triangle symbol located on the lid with the triangle symbol located on the pitcher's handle. Press down on the handle until you hear a click. The triangle symbols MUST be aligned for the lid to lock into place. For your safety, the blender will not power on if the lid is incorrectly assembled.
To remove the lid, press the RELEASE button on the top of the lid and lift up on the handle. To remove the stacked blade assembly, carefully grasp the blade assembly by the top of the shaft and remove from the pitcher. The pitcher can then be emptied.
To pause the blending cycle, press again on the same button that you initially selected. You can pause the program at any time. To stop a program completely, press the power button.
This indicates your pitcher is not installed properly. Place the Stacked Blade Assembly into the pitcher and lock the lid into place. Then make sure the container is correctly assembled on the motor base. Turn the Pitcher clockwise to lock onto the motor base. You should hear an audible click when the container locks into place. Press the power button. The unit should now be on and the power button should be illuminated.
Do not use ice that has been sitting out or has started to melt. Use ice straight from the freezer. b. Start with a few pulses and then use a continuous blending cycle.
Be sure the unit is properly connected to an electrical outlet. b. Place the Stacked Blade Assembly into the pitcher and lock the lid into place. Then make sure the container is correctly assembled on the motor base. Turn the pitcher clockwise to lock onto the motor base. You should hear an audible click when the container locks into place. c. Press the power button. The unit should now be on and the power button should be illuminated.
Press selected program to pause operation or press power button to cancel selected program. When blades have completely stopped spinning, remove the pitcher from base by rotating it counterclockwise and lifting it up. Once the container is removed from the base, unplug the power cord from the outlet.